Stjohn's RV-7

1 hour.
This went surprisingly quickly. The full-scale drawing of the F-703B angle was a big help. I was able to mark off the notches by laying the angle down on the drawing and marking everything. Of course, you should check, because there’s another ‘full scale’ part on that same drawing that’s 1/2″ longer than the stated dimensions.
The panel reinforcing angle is made out of .063 , and it stiffens the panel. Notches need to be cut into it along the length so it can bend around the curved edge of the panel. I haven’t deburred it yet, that’s another fun adventure waiting for me.