Stjohn's RV-7

6 hours.
Over the last couple of days I’ve been reassembling some of the bits and pieces I had to take off to paint the interior. The flap motor and brace is back in, the fuselage gussets are in and torqued, and the roll bar is finally in and torqued with the center channel riveted on. I also dimpled the firewall for the panel support ribs. That’s the good stuff.
Now for the fail. I tried to install the trim servo. I messed up drilling the bearing block, but that was OK, I was able to salvage it. The crap part is, I cut off the trim servo arm a little short. There’s not enough shaft left to drill the cotter pin hole. Ordered new part. Grr.